Cisco Cisco TelePresence MX700 Folheto

Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0 

Quick Reference Guide

D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013. 

www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved. 

4

Introduction

This document describes the tasks you must perform to start 

using your Cisco TelePresence endpoints on Cisco Unified 

CM (CUCM). 

This guide describes TC6.0 and CUCM 9.0, but most 

configurations will also apply to CUCM 8.6.2. Note that if you 

are configuring CUCM 8.6.2 you may find that some menus 

have changed.

Products covered by this guide

Cisco TelePresence endpoints:

•  TC 5.0 and later: MX200, MX300, EX90, EX60, Codec 

C90, Codec C60, Codec C40, Profiles w/ Codec C 

Series, Quick Set C20 

•  TC 5.1 and later: SX20 Quick Set

Cisco Unified CM – CUCM 9.0

Prerequisite

Users of this guide should be familiar with configuration of the 

Cisco Unified CM and Cisco TelePresence endpoints.

This document do not describe the basic configuration of the 

endpoint, such as user accounts, network configuration, date 

& time, etc. Refer to the user documentation:

This document do not describe configuration of the CUCM 

such as voice mail, shared lines, call forward, etc. Refer to the 

user documentation:

Before you start

In most cases a factory reset of the endpoint is not needed 

before provisioning it to the Cisco Unified CM. But, in some 

cases it is recommended to factory reset the endpoint before 

provisioning: 

•  When the system has been used with Cisco 

TelePresence Management Suite (TMS), or a similar 

system.

•  When the system is re-deployed to another user.
•  When changing the security configuration.
•  When moving the system to another security 

environment.

Factory reset is described in the Appendices section. Refer to 

Contents

Introduction

Endpoint configuration

CUCM configuration

Setting passwords

Appendices

Introduction