Cisco Cisco TelePresence MX700 Folheto
Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0
Quick Reference Guide
D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
29
API
Touch
How to factory reset the endpoint
You can reset the endpoint to its factory defaults by:
• The Touch controller, if you have one.
• The web interface, which available for all endpoints.
• The command line interface by issuing an API command.
• The power button (SX20/EX60/EX90).
• The web interface, which available for all endpoints.
• The command line interface by issuing an API command.
• The power button (SX20/EX60/EX90).
It is not possible to undo a factory reset.
When factory resetting the endpoint the following happens:
• The call logs will be deleted.
• All system parameters will be reset to default values.
• All files that have been uploaded to the system will be
• All system parameters will be reset to default values.
• All files that have been uploaded to the system will be
deleted.
• The Release and Option keys will be preserved.
• Automatic restart of the system.
• Automatic restart of the system.
Notification on the main screen
The system will confirm the factory reset by displaying a
The system will confirm the factory reset by displaying a
notification on the main screen when up and running again.
The notification disappears after approximately 10 seconds.
Basic configuration after the factory reset
This document do not describe the basic configuration of
This document do not describe the basic configuration of
the endpoint, such as user roles, network configuration, date
& time, or location settings, etc. You can read about these
topics in the
1. Tap gently on the Touch screen if the unit is in sleep
mode.
2. Navigate to
Settings ( ) > Administrator > Reset.
3. Tap the
Factory Reset
button.
4. The system will revert to the default factory settings and
automatically restart. This will take a few minutes.
1. Open a web browser and enter the IP address of the
video system in the address bar.
2. Navigate to
Maintenance > Factory Reset
.
3. Read the provided information carefully before you check
the
I want to reset...
check box
4. Click
Perform a factory reset
.
5. The system will revert to the default factory settings and
automatically restart. This will take a few minutes.
Tap
Settings ( ) > System Information
on the Touch
controller to find the system's IP address (IPv4 or IPv6).
Power
button
1. Power down the system by pressing gently and hold the
power button until the system shuts down. The power
LED turns off.
2. Press gently and hold the power button for 10 seconds.
During this period the power LED will remain off.
3. Release the button and within four seconds, press twice.
During this period the power LED will blink.
4. The system will revert to the default factory settings and
automatically restart. When up and running again the LED
lights continuously.
If you failed to press the power button twice within the
four seconds, the system will not revert to the default
factory settings, and you will not see the confirmation
message. If this happens, go back to Step 1.
1. Start a command line interface (for example PuTTY).
Enter the host name (or IP address) of the codec and set
connection type to SSH.
2. Log in with the appropriate username and password.
3. Run the following command:
xCommand SystemUnit
FactoryReset Confirm: Yes
4. The system will revert to the default factory settings and
automatically restart. This will take a few minutes.
Applies to SX20/EX60/EX90
WEB
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
Appendices