Cisco Cisco Firepower Management Center 2000 Guia Do Programador
Version 5.3
Sourcefire 3D System eStreamer Integration Guide
410
Configuring eStreamer
Configuring eStreamer on the eStreamer Server
Chapter 6
11. Press Enter to accept the default gateway from the
eth0
interface.
The following prompt appears:
Are these settings correct? (y or n)
12. Check the settings. If they are correct, type
y
and press Enter.
The following prompt appears:
Do you wish to configure IPv6? (y or n
)
13. IPv6 is not supported for this feature. Type
n
and press Enter.
The Defense Center confirms that the
eth1
interface is configured:
Updated network configuration.
14. After you configure
eth1
, type the command
manage_estreamer.pl
to start
the eStreamer configuration utility.
The following menu appears:
The following menu appears:
**************** Configuration Utility **************
1 status
2 disable
3 enable
4 restart
5 send IDS events
6 don't send IDS events
7 send Packet Data
8 don't send Packet Data
9 add Client
10 delete Client
11 set EStreamer Interface
0 Exit
************************************************************
Enter choice:
**************** Configuration Utility **************
15. Type choice
11
and press Enter.
16. Type
eth1
and press Enter.
************************************************************
Enter choice: 11
Enter Interface Name% eth1
Reloading EStreamer... at
/usr/local/sf/lib/perl/5.10.1/SF/EStreamer.pm line 449.
/usr/local/sf/lib/perl/5.10.1/SF/EStreamer.pm line 449.
**************** Configuration Utility **************
If you have not configured
eth1
, you will receive the warning:
IPv4 or IPv6 addresses are not assigned to the interface: eth1
..