Cisco Cisco IOS Software Release 12.2(11)YV

Enable no cdp advertise-v2 and no cdp run commands.

tftp fails with NAT overload when the router listens for tftp traffic on a non-standard port.

Dial-on-demand routing (DDR) is normally triggered by traffic going in the direction opposite the 
direction for which it is enabled. When DDR is enabled on the Cisco 806 router for inbound traffic, one 
does not expect DDR to activate upon detecting incoming traffic. However, dial-on-demand router does 
activate, and the router is assigned an IP address.

A Cisco 827-4V router configured for traffic shaping with constant bit rate (CBR) and variable bit 
rate-non real-time (VBR-nrt) permanent virtual circuits (PVCs) will have the traffic over the CBR PVC 
affecting throughput on the VBR-nrt PVC. The CBR PVC will also not be shaped and will be send at 
line rate.

Cisco 827-4V router reloads when debug vtsp all is enabled for T.38 fax relay with Cisco Fallback 
option and when a Cisco fax-relay call is received.

The following sections describe the documentation available for the Cisco 836 and SOHO 96 routers. 
Typically, these documents consist of hardware and software installation guides, Cisco IOS 
configuration and command references, system error messages, feature modules, and other documents. 
Documentation is available as printed manuals or electronic documents, except for feature modules, 
which are available online on Cisco.com and the Documentation CD.

Use these release notes with the documents listed in the following sections:

The following documents are specific to Release 12.2 and apply to Release 12.2(11)YV2. They are 
located on Cisco.com and the Documentation CD (under the heading Service & Support):

To reach the 

, click this path:

:

:

 Release 12.2

:

 Release Notes

:

 Cisco IOS