Cisco Cisco IOS Software Release 12.2(14)SZ
MPLS AToM—Ethernet over MPLS for the Cisco 7304 Router
Configuration Examples
10
Cisco IOS Release 12.2(14)SZ and 12.2(18)S
Local LDP Identifier:
15.15.15.15:0
Discovery Sources:
Interfaces:
POS3/0 (ldp): xmit/recv
LDP Id: 11.11.11.11:0
POS6/0 (ldp): xmit/recv
LDP Id: 12.12.12.12:0
Targeted Hellos:
15.15.15.15 -> 11.11.11.11 (ldp): active, xmit
Step 2
To make sure the label distribution session has been established, issue the show mpls ldp neighbors
command. The output shows that:
command. The output shows that:
•
The P routers has LDP sessions with PE1 and PE2.
•
The LDP session is operational.
•
Messages are being sent and received.
P# show mpls ldp neighbor
Peer LDP Ident: 11.11.11.11:0; Local LDP Ident 15.15.15.15:0
TCP connection: 11.11.11.11.646 - 15.15.15.15.11072
State: Oper; Msgs sent/rcvd: 80/71; Downstream
Up time: 00:48:50
LDP discovery sources:
POS3/0, Src IP addr: 30.5.0.1
Addresses bound to peer LDP Ident:
8.0.5.20 11.11.11.11 180.3.0.2 20.20.20.3
200.200.200.5 30.5.0.1
Peer LDP Ident: 12.12.12.12:0; Local LDP Ident 15.15.15.15:0
TCP connection: 12.12.12.12.646 - 15.15.15.15.11169
State: Oper; Msgs sent/rcvd: 29/27; Downstream
Up time: 00:16:28
LDP discovery sources:
POS6/0, Src IP addr: 30.5.0.4
Addresses bound to peer LDP Ident:
8.0.6.3 12.12.12.12 30.5.0.4
Configuration Examples
The following configuration example lists the commands for enabling MPLS to transport Layer 2 VLAN
packets between two endpoints.
packets between two endpoints.
illustrates the network configuration that the configuration
commands reference.
Figure 2
Configuring Ethernet Over MPLS
P
PE2
CE2
CE1
PE1
59525