Cisco Cisco 2106 Wireless LAN Controller
12
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.1.185.0
OL-31336-01
New and Changed Information
Using the GUI to View Transmit Power Levels for 1500 Series Access Points
Follow these steps to view transmit power levels for an AP1505 or AP1510 using the GUI.
Step 1
Click Wireless > Access Points > Radios > 802.11a/n or 802.11b/g/n to access the 802.11a/n (or
802.11b/g/n) Radios page.
802.11b/g/n) Radios page.
Step 2
Hover your cursor over the blue drop-down arrow for the desired access point and choose Detail. The
802.11a/n (or 802.11b/g/n) AP Interfaces > Details page appears (see
802.11a/n (or 802.11b/g/n) AP Interfaces > Details page appears (see
Figure 1
802.11a/n AP Interfaces > Details Page
This page shows the current transmit power level under the “Tx Power” section.
Using the CLI to View Transmit Power Levels for 1500 Series Access Points
To view transmit power levels for an AP1505 or AP1510 using the CLI, enter these commands:
show ap config 802.11a Cisco_AP
show ap config 802.11b Cisco_AP
Note
The show ap config 802.11a Cisco_AP command is not applicable to the AP1505 because it has only
one radio, the 802.11b/g/n.
one radio, the 802.11b/g/n.