Cisco Cisco 2504 Wireless Controller Guia De Resolução De Problemas
!
interface Port-channel1
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,30-39
switchport mode trunk
end
The command eterchannel load-balance src-dst-ip is also required on the switch globally for
this to work.
this to work.
These are just a few designs implemented by users in order to leverage the wireless service to
their client devices with CUWN.
their client devices with CUWN.
Guidelines to Deploy the Cisco 2500 Wireless Controller
Ethernet ports on the Cisco 2500 Series Wireless Controllers do not work as Switch ports (that is,
two machines directly connected to these ports cannot communicate with each other). You should
not connect servers, such as DHCP, TFTP, and so on, on these ports and expect Wireless Clients
and APs to receive an IP address from this DHCP server.
two machines directly connected to these ports cannot communicate with each other). You should
not connect servers, such as DHCP, TFTP, and so on, on these ports and expect Wireless Clients
and APs to receive an IP address from this DHCP server.
Ethernet ports on the Cisco 2500 Series Wireless Controller should only be used to connect/uplink
to an infrastructure network configured as a data interface (management interface and dynamic
interfaces) or an AP-managers interface.
to an infrastructure network configured as a data interface (management interface and dynamic
interfaces) or an AP-managers interface.
If multiple Ethernet ports on a Cisco 2500 Series Wireless Controller are uplinked to an
infrastructure switch, you should make sure data interfaces (management or dynamic interfaces)
or AP-managers interfaces are configured for these uplinked physical ports. Physical Ethernet
ports which are used as an uplink to an infra switch should not be left unconfigured. This might
result in unexpected behaviors.
infrastructure switch, you should make sure data interfaces (management or dynamic interfaces)
or AP-managers interfaces are configured for these uplinked physical ports. Physical Ethernet
ports which are used as an uplink to an infra switch should not be left unconfigured. This might
result in unexpected behaviors.
Multicast unicast is not a supported configuration on the Cisco 2500 Series Wireless Controller. As
a result, HREAP/Flexconnect APs are not able to receive multicast traffic because
HREAP/Flexconnect APs only work with multicast unicast.
a result, HREAP/Flexconnect APs are not able to receive multicast traffic because
HREAP/Flexconnect APs only work with multicast unicast.
Web Express Setup
In Version 7.6.130 and later, the WLC offers an Express version of the GUI. It is a way to
configure it via the GUI, but is also a simplified monitoring dashboard that shows the first time you
connect.
configure it via the GUI, but is also a simplified monitoring dashboard that shows the first time you
connect.
On the first GUI connection you will see this: