Cisco Cisco 4100 Series Wireless LAN Controller Referências técnicas

config ap mode

Cisco Wireless LAN Controllers communicate with Cisco 1000 Series lightweight access points in one of 
three modes: local (normal), reap (remote office, must connect to a Cisco 1030 remote edge light-
weight access point), or monitor (listen-only). To change a Cisco Wireless LAN Controller 
communication option for an individual Cisco 1000 Series lightweight access point, use the config ap 
mode command.
Note that the bridge mode can be set only on Cisco 1030 remote edge lightweight access points.

config ap mode

Configure boot option.

local/reap/monitor/

Set the Cisco 1000 Series lightweight access point

rogue/sniffer/bridge

for local (normal), reap (remote office), monitor 
(listen-only), rogue (rogue detector), sniffer (wire-
less sniffer) or bridge (bridge access point) mode.

<Cisco AP>

Name of the Cisco 1000 Series lightweight access 
point.

Local.

>config ap mode local AP01
sets the Cisco Wireless LAN Controller to communicate with AP01 in local 
(normal) mode.

>config ap mode reap AP91
sets the Cisco Wireless LAN Controller to communicate with Cisco 1030 remote 
edge lightweight access point AP91 in remote office mode.

>config ap mode monitor AP02
sets the Cisco Wireless LAN Controller to communicate with AP02 in monitor 
(listen-only) mode.

>config ap mode rogue AP91
sets the AP91 in rogue access point detector mode.

>config ap mode sniffer AP02
sets the AP02 in wireless sniffer mode. It will capture and forward all the 
packets from the clients on that channel to a remote machine that runs 
AiroPeek (A packet analyzer for IEEE 802.11 wireless LANs). It will include 
information on timestamp, signal strength, packet size and so on.

>config ap mode bridge AP91
sets the AP91 in bridge mode.
Note that the bridge mode can be set only on a Cisco 1030 remote edge light-
weight access point. 

show ap config