Cisco Cisco Aironet 3500e Access Point Ficha De Dados
11
Cisco Aironet Six-Element Dual-Band MIMO Patch Array Antenna (AIR-ANT25137NP-R)
OL-23461-01
Installing the Antenna
Figure 3
Moving the Adjustment Bolt from the Shipping Position
Step 3
Reinsert the adjustment bolt in the adjustment slot and tighten it only slightly.
Step 4
Determine the mounting location for the antenna.
Note
The fasteners and mounting surface should be capable of maintaining a
minimum pullout force of 150 pounds (68 kg) to support the weight of the
antenna plus the potential wind loading on the antenna.
minimum pullout force of 150 pounds (68 kg) to support the weight of the
antenna plus the potential wind loading on the antenna.
Step 5
Attach the mounting bracket to the wall or ceiling using two screws or bolts
attached to the mounting surface through the top two mounting holes on the
bracket (
attached to the mounting surface through the top two mounting holes on the
bracket (
).
Step 6
When the antenna is secured on the wall with two bolts, adjust the antenna
position so you can access the two mounting holes on lower part of the bracket.
position so you can access the two mounting holes on lower part of the bracket.
Use a 10-mm wrench to loosen the elevation adjustment bolt and the elevation
pivot bolt (
pivot bolt (
). Swing the antenna out of the way and tighten the adjustment
and pivot bolts slightly.
Step 7
Install the remaining two mounting bolts.
Step 8
Adjustment the azimuth (side-to-side position) and elevation (up-and-down
position) of the antenna. Use a 10-mm wrench to loosen the adjustment bolts and
the pivot bolts (
position) of the antenna. Use a 10-mm wrench to loosen the adjustment bolts and
the pivot bolts (
). Azimuth angle can be adjusted ±25 degrees and
elevation can be adjusted ±60 degrees.