Cisco Cisco Packet Data Gateway (PDG) Guia Da Instalação
Card Installation
▀ Circuit Cards
▄ ASR 5500 Installation Guide
68
Circuit Cards
The installation procedure described below is identical for all circuit cards in the chassis. Circuit cards include: SSC,
FSC, DPC/UDPC, DPC2/UDP2, MIO/UMIO.
FSC, DPC/UDPC, DPC2/UDP2, MIO/UMIO.
Prerequisites
Caution:
During installation, maintenance, and/or removal, wear a grounding wrist strap connected to the
ASR 5500 chassis to avoid ESD damage to the components. Failure to do so could result in damage to sensitive
electronic components and potentially void your warranty.
electronic components and potentially void your warranty.
Important:
Save several of the shipping cartons and ESD protective bags for use if a card must be returned to
Cisco for fault analysis.
Important:
On a chassis equipped with the cable management tray, you must lower the tray to insert rear circuit
cards. Refer to the Lowering the Cable Management Tray section in the Cable Management System Installation
appendix. The cable management tray can be installed after all rear cards have been installed.
appendix. The cable management tray can be installed after all rear cards have been installed.
Important:
Install cable management brackets on MIO cards before inserting the card into the chassis. Refer to
the Installing Cable Management Brackets section in the Cable Management System Installation appendix.
Installing Circuit Cards
Step 1
Determine the type of card you are installing. The card type is identified by the label within the bottom ejector handle of
the card.
the card.
Step 2
Determine in which chassis slot to install the card based on the information in the tables at the beginning of this chapter.
Step 3
Install front cards from Right to Left. Complete the installation sequence described in Steps 5 through 9 for each card
before proceeding to the next card. This includes tightening the captive screws in the ejector handles using a Phillips #2
screwdriver.
before proceeding to the next card. This includes tightening the captive screws in the ejector handles using a Phillips #2
screwdriver.
Step 4
Install rear cards from Left to Right. Complete the installation sequence described in Steps 5 through 9 for each card
before proceeding to the next card. This includes tightening the captive screws in the ejector handles using a Phillips #2
screwdriver.
before proceeding to the next card. This includes tightening the captive screws in the ejector handles using a Phillips #2
screwdriver.
Step 5
Position both ejector handles on the circuit card to be up and away (outwards) from the front panel of the card.
Step 6
Properly support the weight of the card and align it with the upper and lower card guides of the chassis slot. Gently slide
the card into the slot until the levers touch the chassis frame.
the card into the slot until the levers touch the chassis frame.