Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Border Gateway Protocol Configuration Mode Commands
timers ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
timers
This command configures BGP routing timers.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
Remove the user specified timer values from the router‘s configuration. The timer values are reset to the
default values.
default values.
Default: 30
The interval, in seconds, to wait between sending keepalive packets. Must be an integer from 0 through
65535.
The interval, in seconds, to wait between sending keepalive packets. Must be an integer from 0 through
65535.
Default: 90
The interval, in seconds, after which the neighbor is considered dead if keepalive messages are not received.
Must be an integer from 0 through 65535.
The interval, in seconds, after which the neighbor is considered dead if keepalive messages are not received.
Must be an integer from 0 through 65535.
Default: 0
The interval, in seconds, that is the minimum acceptable hold time from a neighbor. Must be an integer from
0 through 65535. The default is 0 so that there is no restriction on the hold time received in an OPEN
message from the peer.
The interval, in seconds, that is the minimum acceptable hold time from a neighbor. Must be an integer from
0 through 65535. The default is 0 so that there is no restriction on the hold time received in an OPEN
message from the peer.
Usage
Use this command to configure the how long to wait between sending keepalive packets and how long to wait
for a keepalive before considering a a neighbor dead.
for a keepalive before considering a a neighbor dead.
Example
The following command sets the keepalive interval to 2 minutes and the holdtime interval to 3 minutes:
The following command sets the keepalive interval to 2 minutes and the holdtime interval to 3 minutes: