Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Global Configuration Mode Commands
threshold route-service bgp-routes ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold route-service bgp-routes
This command configures the threshold limits for route services to BGP routes.
Product
PDSN
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold rate for BGP routes on the system that must be met or exceeded within the polling interval
to generate an alert or alarm.
The high threshold rate for BGP routes on the system that must be met or exceeded within the polling interval
to generate an alert or alarm.
can be configured to any integer value between 0 and 100. A value of 0 disables the
threshold.
Default: 0
The low threshold rate for BGP routes on the system that maintains a previously generated alarm condition. If
the number of setup failures falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
The low threshold rate for BGP routes on the system that maintains a previously generated alarm condition. If
the number of setup failures falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
can be configured to any integer value between 0 and 100. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to configure a threshold in percentage of maximum BGP routes allowed. If the percentage
of the number of BGP routes in a context (including all VRFs) reaches
of the number of BGP routes in a context (including all VRFs) reaches
, a notification is
generated. Optionally, if the threshold subsystem is configured in ‗alarm‘ mode, a Threshold_Clear
notification is generated when the percentage of the number of BGP routes in a context (including all VRFs)
goes below
notification is generated when the percentage of the number of BGP routes in a context (including all VRFs)
goes below
. The maximum number of BGP routes is also sent by BGP task when getting the
stats
Alerts or alarms are triggered for BGP routes based on the following rules:
Alerts or alarms are triggered for BGP routes based on the following rules:
Enter condition: Actual number of call setup failures > High Threshold
Clear condition: Actual number of call setup failures < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.