Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Global Configuration Mode Commands
threshold rp-setup-fail-rate ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold rp-setup-fail-rate
Configures RP setup failure rate thresholds.
Product
PDSN
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold rate for RP setup failures experienced by the system that must be met or exceeded within
the polling interval to generate an alert or alarm.
The high threshold rate for RP setup failures experienced by the system that must be met or exceeded within
the polling interval to generate an alert or alarm.
can be configured to any integer value between 0 and 100. A value of 0 disables the
threshold.
Default: 0
The low threshold rate for RP setup failures experienced by the system that maintains a previously generated
alarm condition. If the number of setup failures falls beneath the low threshold within the polling interval, a
clear alarm will be generated.
The low threshold rate for RP setup failures experienced by the system that maintains a previously generated
alarm condition. If the number of setup failures falls beneath the low threshold within the polling interval, a
clear alarm will be generated.
can be configured to any integer value between 0 and 100. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
RP setup failure rate thresholds generate alerts or alarms based on the rate of call setup failures experienced
by the system during the specified polling interval. The failure rate is the percentage of failures as determined
by number of Registration Request Messages rejected divided by the total number of Registration Request
Messages received.
Alerts or alarms are triggered for RP setup failure rates based on the following rules:
by the system during the specified polling interval. The failure rate is the percentage of failures as determined
by number of Registration Request Messages rejected divided by the total number of Registration Request
Messages received.
Alerts or alarms are triggered for RP setup failure rates based on the following rules:
Enter condition: Actual number of call setup failures ³ High Threshold
Clear condition: Actual number of call setup failures < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Example
The following command configures a RP setup failure rate high threshold of
The following command configures a RP setup failure rate high threshold of
and a clear threshold of
: