Cisco Cisco Packet Data Gateway (PDG) Manual De Manutenção
Configuration Management
Generally Available 06-30-2010
3-50
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
duplicate-session-detection
Configured in the PDIF-Service mode,
duplicate-session-detection
configures the
PDIF to check for any attempt to set up a call after a MS comes back into WiFi range using
either the IMSI or NAI address from a call lost after the MS initially went out of WiFi AP
range. Detection can be based on either the IMSI or NAI (default) address. If NAI is used, it
must be the NAI from Stage One authentication.
either the IMSI or NAI address from a call lost after the MS initially went out of WiFi AP
range. Detection can be based on either the IMSI or NAI (default) address. If NAI is used, it
must be the NAI from Stage One authentication.
CLI (PDIF-Service Config Mode)
duplicate-session-detection { NAI | IMSI }
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
group
Diffie-Hellman Group 14 has been added to the existing Groups 1, 2 and 5 for IKEv2
security exchanges.
security exchanges.
CLI (IKEv2 Security Association Configuration Mode
group { 1 | 2 | 5 | 14 }
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
ignore-rekeying-requests
Configured in the Crypto Template Payload Config Mode, this is a new command that
prevents the creation of a CHILD SA.
prevents the creation of a CHILD SA.
CLI (Crypto Template Payload Config Mode)
ignore-rekeying-requests
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
ikev2-ikesa
Configured in the Crypto Template Config Mode, the keyword
rekey
has been added to
ikev2-ikesa
commands. It specifies if IKESA rekeying should occur before the
configured lifetime expires (at approximately 90% of the lifetime interval). Default is
no
ikev2-ikesa rekey.
CLI (Crypto Template Config Mode)
[ no ] ikev2-ikesa [ rekey ]
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.