Cisco Cisco Packet Data Gateway (PDG) Manual De Manutenção
Generally Available 06-30-2010
New Configuration Commands
3-51
ip source-violation
Source validation requires the source address of received packets to match the IP address
assigned to the subscriber. IP source-violation sets parameters for allowing bad packets
before terminating the call.
assigned to the subscriber. IP source-violation sets parameters for allowing bad packets
before terminating the call.
CLI (PDIF-Service Config Mode)
ip source-violation { clear-on-valid-packet | drop-limit num | period
secs }
no ip source-violation clear-on-valid-packet
Web Element Manager Path
Configuration | PDIF Service | Configuration
ipv6 address
Enable this ipv6 address when the Service Redundancy Protocol determines this chassis to
be active for Session Recovery .
be active for Session Recovery .
CLI (loopback-interface-config-mode)
ipv6 address 2001:268:2008:b::1021/128 srp-activate
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
nai
Configures the NAI parameters to be used for the crypto template IDr. This configured IDr
is sent from PDIF to MS in the first IKEv2 AUTH response. The default configuration is
is sent from PDIF to MS in the first IKEv2 AUTH response. The default configuration is
no
nai
. As a result, the default behavior is for the PDIF-service IP address to be sent as the IDr
value with the type ID_IP_ADDR.
CLI (Crypto-Template Config Mode)
[ default | no ] nai idr name id-type { rfc822-addr | fqdn | ip-addr |
key-id }
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
radius accounting pdif trigger-policy
Configures the policy for dealing with packet overflow.
CLI (AAA Group Config Mode)
r
adius accounting pdif trigger-policy { counter-rollover | standard }
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.