Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Interchassis Session Recovery
▀ Configuring Interchassis Session Recovery (ICSR)
▄ Cisco ASR 5000 Series Enhanced Feature Configuration Guide
OL-22982-01
Verifying BGP Configuration in Destination Context
Step 1
Verify your BGP configuration by entering the following command in Exec Mode:
Disabling Bulk Statistics Collection on a Standby System
You can optionally configure bulk statistics not to be collected from a system when it is in the standby mode of
operation.
operation.
Important:
When this feature is enabled and a system transitions to standby state any pending accumulated
statistics data is transferred at the first opportunity. After that no additional statistics gathering takes place until the
system comes out of standby state.
system comes out of standby state.
Use the following example to disable the bulk statistics collection on a standby system.
Notes:
Repeat this procedure for both systems.
Verifying the Primary and Backup Chassis Configuration
These instructions are used to compare the ICSR configuration on both chassis.
Step 1
Enter the following command on both chassis at the Exec mode:
Verify that both chassis have the same srp configuration information. The output looks similar to following: