Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
IP Security
Crypto Map and Interface Association ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22982-01
Crypto Map and Interface Association
This section provides instructions for applying manual or ISAKMP crypto maps to interfaces configured on the system.
Dynamic crypto maps should not be applied to interfaces.
Dynamic crypto maps should not be applied to interfaces.
Important:
This section provides the minimum instruction set for applying manual or ISAKMP crypto maps to
an interface on the system. For more information on commands that configure additional parameters and options, refer
to the Command Line Interface Reference.
to the Command Line Interface Reference.
To apply the crypto maps to an interface:
Step 1
Configure a manual or ISAKMP crypto map by applying the example configuration in any of the following sections:
Step 2
Apply desired crypto map to system interface by following the steps in the
section
Step 3
Verify your manual crypto map configuration by following the steps in the
Step 4
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Applying Crypto Map to an Interface
Use the following example to apply an existing crypto map to an interface on your system:
Notes:
<
> is the system context in which the interface is configured to apply crypto map.
<
> is the name of a specific interface configured in the context to which the crypto map will
be applied.
<
> is name of the preconfigured ISAKMP or a manual crypot map.