Cisco Cisco Aironet 350 Wireless LAN Client Adapter

CSCeh00792—Saved LEAP username and password not used when Novell client installed

When Windows XP Service Pack 1 or Service Pack 2 is installed followed by ADU and Novell 
Client 4.90 Service Pack 2 (4.90.2.20040617) and ADU is configured for LEAP and WPA with a 
saved username and password, you are prompted to enter your username and password upon reboot. 
Although ADU has your saved username and password, it does not use them. This issue is resolved 
in ADU 2.0.

CSCeh31338—Client fails domain login when Windows Auto Admin Logon enabled

The client is unable to log into a domain when Windows Auto Admin Logon is enabled. This issue 
is resolved in ADU 2.0.

CSCin57337—SSID not shown in ASTU Tool Tip window

When the client adapter is not associated to an access point, the Tool Tip window in ASTU does not 
show an SSID. In ADU 2.0, when the client adapter is not associated and auto profile selection is 
disabled, the Tool Tip window now shows the profile’s SSID. However, when the client adapter is 
not associated and auto profile selection is enabled, the SSID still does not appear.

CSCin75469—LEAP Authentication Status window always in foreground

The LEAP Authentication Status window always appears in the foreground, even after another 
application is selected. This issue is resolved in ADU 2.0.

The following caveats, which are listed as open caveats in the Release Notes for Install Wizard 1.2, have 
been closed and are not resolved in Install Wizard 2.0.

CSCec08294—Client remains in access point’s association table

The client remains in the access point’s association table for approximately 30 minutes after it has 
been disabled.

CSCec39604—EAP-TLS authentication attempts fail for users with zero-length passwords

EAP-TLS authentication attempts fail for users with zero-length passwords. To work around this 
problem, set up a Windows password that contains at least one character.

CSCed23644—DHCP does not operate if MIC is enabled on VxWorks access points

DHCP does not operate with CB21AG and PI21AG client adapters if MIC is enabled on VxWorks 
access points. To work around this problem, upgrade the VxWorks access points to firmware version 
12.04 or later.

CSCee14610—PEAP authentication attempts fail for users with zero-length passwords

PEAP authentication attempts fail for users with zero-length passwords. To work around this 
problem, set up a Windows password that contains at least one character.

CSCef54644—Problem getting IP address on 802.11a radio after rebooting switch

When the client adapter is set to operate in 5-GHz, 54-Mbps wireless mode, the client may fail to 
get an IP address via DHCP after the upper switch reboots. To work around this problem, shut down 
both the client adapter and the access point to which it is associated and reauthenticate.