Cisco Cisco Packet Data Gateway (PDG)
Accounting Policy Configuration Mode Commands
▀ session
▄ Command Line Interface Reference, StarOS Release 18
248
session
This command controls the behavior of whether to send or suppress the ACR-Interim records when the UE is idle.
Product
P-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > Accounting Policy Configuration
configure > context context_name > policy accounting policy_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-accounting-policy)#
Syntax
[ default | no ] session idle-mode suppress-interim
default
The default behavior is to send accounting interim records even when the UE is in idle state and when there is
no data to report.
no data to report.
no
Specifies to send the accounting interim records even when the UE is in idle state and when there is no data
to report.
to report.
suppress-interim
Suppresses the ACR-I records when there is no data to report or the UE is in idle mode.
Usage
This CLI configuration is used to control sending of ACR-I records when the UE is in idle mode and when
there is no data to report.
In a scenario where there is no data to report, upon configuring the CLI command “
there is no data to report.
In a scenario where there is no data to report, upon configuring the CLI command “
session idle-mode
suppress-interim
”, a call is established, AII timer (or any other event for which an Interim needs to be
generated) happens, and ACR-I will be suppressed.
When there is data to report, on configuring the CLI command “
When there is data to report, on configuring the CLI command “
session idle-mode suppress-
interim
”, a call is established, AII timer (or any other event for which an Interim needs to be generated)
happens, and ACR-I will be sent out.
When there is data to report for the previous events, the following behavior is observed:
When there is data to report for the previous events, the following behavior is observed:
1. the CLI command “
session idle-mode suppress-interim
” is configured and a call is
established.
2. QoS-Change happens (or any other event for which the container needs to be cached) happens,
containers are cached.
3. AII timer (or any other event for which an Interim needs to be generated) happens, but there is no
data to report with this event.
4. ACR-I will be sent with the previously cached containers (QoS-Change in this case).