Cisco Cisco Packet Data Gateway (PDG)
ACS Readdress Server List Configuration Mode
▀ response-timeout
▄ Command Line Interface Reference, StarOS Release 16
628
response-timeout
This command allows you to configure the time duration for which the system will wait for a response from the server
before marking it unreachable.
before marking it unreachable.
Important:
This command is license dependent. For more information contact your Cisco account representative.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Readdress Server List Configuration
active-charging service service_name > readdress-server-list server_list_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-readdress-server-list)#
Syntax
response-timeout response_timeout
default response-timeout
default
Configures this command with its default setting.
Default: 1000 milliseconds
Default: 1000 milliseconds
response_timeout
Specifies the time duration (in milliseconds) for which the system will wait for a response from the server
before marking it unreachable.
before marking it unreachable.
response_timeout
must be an integer from 1 through 10000.
Important:
If not explicitly configured, the default value of 1000 milliseconds will be used.
Usage
Use this command to configure the time duration (in milliseconds) for which the system will wait for a
response from the server before marking it unreachable.
response from the server before marking it unreachable.
Example
The following command sets the server response timeout to
4500
milliseconds:
response-timeout 4500