Cisco Cisco Packet Data Gateway (PDG)
ACS Readdress Server List Configuration Mode
server ▀
Command Line Interface Reference, StarOS Release 16 ▄
629
server
This command allows you to configure the DNS server(s) to which flow will be readdressed.
Important:
This command is license dependent. For more information contact your Cisco account representative.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Readdress Server List Configuration
active-charging service service_name > readdress-server-list server_list_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-readdress-server-list)#
Syntax
server [ipv4_address | ipv6_address ] [ port port_number ]
no server [ ipv4_address|ipv6_address ]
no
If previously configured, disables the specified server configuration.
ipv4_address
Specifies the IP address of the DNS server.
ipv4_address
must be expressed in IPv4 dotted-decimal notation format.
ipv6_address
must be expressed in IPv6 colon-separated-hexadecimal notation.
port port_number
Specifies the TCP port of the DNS server.
port_number
must be an integer from 1 through 65535.
Usage
Use this command to configure the DNS server(s) to which the flow will be readdressed based on the
contents of the Fully Qualified Domain Name (FQDN).
contents of the Fully Qualified Domain Name (FQDN).
Example
The following commands configure the DNS servers for packet flow to
192.168.12.101
,
192.168.12.102
, and
2607:f0d0:1002:51::4/64
:
server 192.168.12.101
server 192.168.12.102