Cisco Cisco Aironet 350 Wireless LAN Client Adapter

This section describes the resolved and open caveats for the software components in Install Wizard 1.8.

The following caveats are resolved in the software components of Install Wizard release 1.8.

CSCdz36298—Itronix GoBook does not fully wake up with 350

The 350 client adapter has 4.25.30 firmware version 4.25.30 and driver version 8.2.3. When the 
wakeup process is started from the GoBook keyboard, the device starts to wake up but then hangs 
at a black or a blank screen with the cursor stuck in the upper left corner.

CSCed45715—Client shows that authentication was started after a successful MAC authentication 
through WDS

After a client was successfully authenticated (configured for open authentication with a WEP key), 
the ACU still shows that the authentication process has started. The status page shows that the client 
is authenticating. However, the client already got a DHCP IP address and can ping the wired 
network.

CSCed56475—Manual PAC provisioning might fail on Novell networks

If the user imports a PAC from an EAP-FAST profile, the PAC can be saved as a private PAC (with 
the correct EAP-FAST settings). When the PAC is saved as a private PAC, it is not found by the login 
module because on Novell networks, the login module does not know the Windows user name. The 
login module must look for the PAC in the global area.

CSCin07193—ACU crashes on removing the card while site survey/link test on

If the user clicks on the Start button of the Site Survey/Link Test window and removes the client 
adapter, the ACU fails.

CSCsb52876—ACU does not send response to ACS with EAP-GTC authentication

ACU does not send a response to the ACS. The EAP conversation is not finished, and the failed 
attempts log is not updated.

CSCsc14393—Client fails to add entry to ACS error log

When an EAP-FAST login fails, the client adapter does not add an entry to the ACS error log 
explaining why the login failed.

CSCsc16865—Client profile reauthenticates for no reason

By design, the client adapter reauthenticates whenever the active profile is changed. However, it is 
possible to change the profile without realizing it. If you open the RF Network screen in ACU for 
the active profile and click OK, the profile may change even though you did not make any changes. 
For an active infrastructure profile, ACU shows the currently in-use channel in the Channel 
drop-down box. If this value is different than the one saved in the profile, clicking OK to exit the 
screen results in a profile change and causes the client to reauthenticate.

CSCsc22249—WZC service exits during PEAP-GTC logon

With the PEAP-GTC supplicant code (CiscoEapPeap.dll) from Install Wizard version 1.6, the 
Wireless Zero Config service must close because of an unexpected problem. This issue is seen when 
the access point is controlled by a controller that is running release 3.0.107 or 3.1.105. This issue is 
not seen on an autonomous IOS access point.

CSCsc30871—ACU release 6.3 EAP-FAST with WPA and TKIP takes over an hour to log on