Cisco Cisco Packet Data Gateway (PDG)
Call Setup Thresholds
Call Setup Thresholds ▀
Thresholding Configuration Guide, StarOS Release 16 ▄
35
Call Setup Thresholds
Threshold monitoring can be enabled for the call setup values described in the following table.
Value
Description
To configure, go to
section:
Number of calls setup
Enables the generation of alerts or alarms based on the number of calls
setup by the system during the polling interval.
setup by the system during the polling interval.
Number of call setup failures
Enables the generation of alerts or alarms based on the number of call
setup failures experienced by the system during the polling interval.
setup failures experienced by the system during the polling interval.
RP setup failure rate
Enables the generation of alerts or alarms based on the rate at which RP
failures are experienced by the system during the polling interval.
failures are experienced by the system during the polling interval.
PPP setup failure rate
Enables the generation of alerts or alarms based on the rate at which PPP
failures are experienced by the system during the polling interval.
failures are experienced by the system during the polling interval.
Number of calls rejected due to
no processing resources being
available
no processing resources being
available
Enables the generation of alerts or alarms based on the number of calls
rejected by the system due to insufficient resources (memory and/or
session licenses) during the polling interval.
rejected by the system due to insufficient resources (memory and/or
session licenses) during the polling interval.
Configuring Call Setup Thresholds
Use the following example to configure call setup thresholds:
configure
threshold call-setup <high_thresh> [ clear <low_thresh> ]
threshold poll call-setup interval <time>
threshold monitoring call-setup
end