Cisco Cisco Aironet 350 Wireless LAN Client Adapter

Perform one of the following:

If your device is connected to a DHCP server, choose Obtain an IP address via DHCP or
Use server-assigned IP address and tap OK.

If your device is not connected to a DHCP server, choose Specify an IP address or Use specific IP 
address and follow these steps:

Enter the IP address, subnet mask, and default gateway address you want to assign to your device. 
They can be obtained from your system administrator.

Choose the Name Servers tab and enter the primary and secondary DNS and WINS you want to 
assign to your device. They can be obtained from your system administrator.

Tap OK.

The driver and client utility installation is complete. To verify that you have properly installed the driver 
and client utilities, check the client adapter’s LEDs. If the installation was successful, the client adapter’s 
green LED blinks.

Refer to the Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and 
Configuration Guide for Windows CE (part number OL-1375-05) for information on configuring 
your client adapter.

This section describes resolved and open caveats for client utility and driver release 2.60 for
Windows CE.

The following caveats are resolved in client utility and driver release 2.60 for Windows CE.

CSCef17203—Syclo Agentry client software may hang when used with EAP-FAST or PEAP

When your client adapter is configured for EAP-FAST or PEAP, Syclo Agentry client software may 
hang when the software first starts and attempts to connect to the database server. Powering the 
Windows CE device off and on enables the application to proceed.

CSCeg07896—Windows CE driver does not have configurable parameters for offline channel scan

The Windows CE driver does not have configurable parameters for offline channel scan, so the user 
is unable to adjust the client’s roaming behavior.