Cisco Cisco Prime Optical 9.8 Guia Do Programador
Cisco Prime Optical 9.8 GateWay/CORBA Programmer Reference Guide
OL-29218-01
261
Description
This interface enables an NMS to request a list of the SNCs using the specified TP at the
specified connection rates. A TP might be a PTP that requires a full list of SNCs using any of its
contained CTPs. A TP might be a CTP or FTP that only requires the SNCs using that CTP or FTP.
Both end CTPs and intermediate CTPs at the same layer are considered. In all cases, only SNCs
that also match the specified connection rate filter are returned.
specified connection rates. A TP might be a PTP that requires a full list of SNCs using any of its
contained CTPs. A TP might be a CTP or FTP that only requires the SNCs using that CTP or FTP.
Both end CTPs and intermediate CTPs at the same layer are considered. In all cases, only SNCs
that also match the specified connection rate filter are returned.
• For the ONS 15310 MA SONET, this method does not report STS-1 SNC on DS1 ports of
DS1_xx cards.
• For the ONS 15310 MA SDH, this method does not report VC4 SNC on E1 ports of
E1_63_E3_3 cards.
• For the ONS 15454 SONET, this method does not report STS-1 SNC on DS1 equipment.
• For the ONS 15454 SDH, this method does not report VC-4 SNC on E1 or E1_42 equipment.
• For CPT 200, CPT 200 SDH, CPT 600, and CPT 600 SDH, see
• For the ONS 15454 SDH, this method does not report VC-4 SNC on E1 or E1_42 equipment.
• For CPT 200, CPT 200 SDH, CPT 600, and CPT 600 SDH, see
• This interface does not report SNCs with duplicate names.
For ONS 15600 SONET and ONS 15600 SDH NEs, if bridge-and-roll is applied, one CTP may be
associated with two SNCs during a transient phase. If Prime Optical invokes this method during
this phase, it reports both SNCs.
associated with two SNCs during a transient phase. If Prime Optical invokes this method during
this phase, it reports both SNCs.
Parameters
Name
Type
Input/
Output
Output
Description
tpName
globaldefs::NamingAttributes_T
In
Termination point for which to
report SNCs.
report SNCs.
connectionLayerRateList
transmissionParameters::LayerRateL
ist_T
ist_T
In
List of rates of the SNCs to report.
If an empty list is specified, all
SNCs of all rates are reported.
If an empty list is specified, all
SNCs of all rates are reported.
how_many
unsigned long
In
Maximum number of SNCs to
report in the first batch.
report in the first batch.
sncList
subnetworkConnection::Subnetwork
ConnectionList_T
ConnectionList_T
Out
First batch of SNCs.
sncIt
subnetworkConnection::SNCIterator
_I
_I
Out
Iterator to retrieve the remaining
SNCs.
SNCs.
Throws