Cisco Cisco Prime Optical 9.6 Guia Do Programador
Cisco Prime Optical 9.6.3 GateWay/CORBA Programmer Reference Guide
OL-28047-01
354
Supported. Prime Optical supports the following values:
– LCASMode_T.MODE_NONE
– LCASMode_T.MODE_SWLCAS
– LCASMode_T.MODE_LCAS
• subnetworkConnection::RoutingMode_T routingMode
Supported. Prime Optical supports the following values:
– RoutingMode_T.COMMONFIBER_ROUTED
– RoutingMode_T.INDEPENDENTFIBER_ROUTED
• globaldefs::NamingAttributes_T aEnd;
Supported. If the topology is an RPR topology, you specify an ML-series equipment name to
use to create the L2 topology. If the topology is a point-to-point topology, Prime Optical
expects this field to be an FTP representing the information up to the slot level of the card
involved in the VCAT SNC.
• globaldefs::NamingAttributes_T zEnd;
Supported. If the topology is an RPR topology, you specify an ML-series equipment name to
use to create the L2 topology. If the topology is a point-to-point topology, Prime Optical
expects this field to be an FTP representing the information up to the slot level of the card
involved in the VCAT SNC.
• subnetworkConnection::SNCCreateDataList_T sncCreateDataList
Supported. At least one L1 SNC is created at the time of VCAT SNC creation. Prime Optical
expects you to specify the create data information required to create the L1 SNCs in the
data structure.
• globaldefs::NVSList_T additionalCreationInfo
Not supported.
• subnetworkConnection::StaticProtectionLevel_T staticProtectionLevel
Not supported. StaticProtectionLevel is specified as part of SNCCreateData_T and
VCATSNCCreateData_T structure.
• globaldefs::NVSList_T additionalInfo
Supported. You can choose to specify bandwidth parameters. By default, bandwidth
parameters have a zero value. If you choose to enter a specific bandwidth value, you must
also specify its corresponding CoS value. The default value for all CoS values is N/A. The sum
of all the bandwidth parameters must be from 1 to 99. The CoS commit value must be from
0 to 7.
The following are the supported bandwidth parameters (Group1Bandwidth and
The following are the supported bandwidth parameters (Group1Bandwidth and
Group2Bandwidth are multicast bandwidth parameters, and their corresponding CoS values
are Group1CoS and Group2CoS):