Cisco Cisco Prime Optical 9.6 Guia Do Programador
Cisco Prime Optical 9.6.3 GateWay/CORBA Programmer Reference Guide
OL-28047-01
355
– Group1Bandwidth
– Group2Bandwidth
– SpMgmtBandwidth
– CommittedBandwidth
– BestEffortBandwidth
– AvvidControlBandwidth
– ClassSpMgmt
– ClassCommitted
– ClassBestEffort
– ClassAvvidControl
– ClassAvvidVoiceVideo
– ClassAReservedBandwidth
– ClassA1Bandwidth
– ClassBCommittedBandwidth
– SpMgmtCoS
– CommittedCoS
– AvvidVoiceVideoCoS
– AvvidControlCoS
– CosCommit
– Group1CoS
– Group2CoS
Group2Bandwidth parameters must be entered along with Group1Bandwidth
parameters. Entering Group2Bandwidth alone creates inconsistency in the L2 topology
table.
If the topology is DOT17_RPR, multicast bandwidth parameters are not supported;
Group1Bandwidth and Group2Bandwidth values are not needed. Group1CoS and Group2CoS
do not apply to DOT17_RPR. For DOT17_RPR topologies, you can specify the absolute
bandwidth values for the three possible classes of traffic (A Reserved, A1, and B Committed).
For the remaining bandwidth parameters, you specify to which class of traffic (Class A, B, or C)
the parameter belongs. For example, ClassSpMgmt belongs to Class C-type traffic.
Throws
Throws
globaldefs::ProcessingFailureException
EXCPT_INTERNAL_ERROR - Raised in case of nonspecific EMS internal failure.
EXCPT_INVALID_INPUT - Raised when the input tpList is invalid or when the
specified layer rate is an invalid layer rate. This exception is also raised
when the user does not specify the corresponding CoS values for the bandwidth
parameters specified.
specified layer rate is an invalid layer rate. This exception is also raised
when the user does not specify the corresponding CoS values for the bandwidth
parameters specified.
EXCPT_ENTITY_NOT_FOUND - Raised when the input tpList does not exist.
EXCPT_UNABLE_TO_COMPLY - Raised when a layer rate is not supported for L2
topology creation or when Prime Optical cannot create the L2 topology for the
specified layer rate. Raised if the VCAT SNC cannot be created and activated
because the CTP conflicts with another VCAT SNC or the NE does not support the
VCAT SNC creation.
topology creation or when Prime Optical cannot create the L2 topology for the
specified layer rate. Raised if the VCAT SNC cannot be created and activated
because the CTP conflicts with another VCAT SNC or the NE does not support the
VCAT SNC creation.