Cisco Cisco Nexus 7000 Series Network Analysis Module (NAM-NX1) Guia Da Instalação

FPGA/ELPD Upgrade Note for Cisco Prime NAM-NX1 6.0

Page 3

Chassis Ejector Support: Enabled
Ejector Status:
Left ejector CLOSE, Right ejector CLOSE, Module HW does support ejector based shutdown, Ejector
policy enabled.

your-‐nam# show analysis module 5 version

App software version 6.0(2)

your-‐nam# show install module 5 impact epld bootflash:n7000-‐s1-‐epld.6.2.5.FH.0.66.gimg

Retrieving EPLD versions... Please wait.

Images will be upgraded according to following table.

Module Type EPLD

Running-Version New-Version Upg-Required

------ ---- ------------- -------------- ----------- ------------
5 LC Power Manager 2.008

2.008 No

5 LC IO 2.003

2.003 No

5 LC DPFPGA-0 0.005

0.062 Yes

5 LC DPFPGA-1 0.005

0.062 Yes

5 LC IO-2 3.001

3.001 No

The NAM versions are highlighted in the table.

Upgrade the NAM FPGA Image for NAM-‐NX1

For NAM-NX1 users, when installing a new NAM-NX1 FPGA image with any supported supervisor card, the
switch is in disruptive mode. For details on when to perform FPGA image upgrade on an NX-OS switch, see the
NX-OS release guide.

During the FPGA upgrade, the NAM-NX1 is held in down state. The NAM 6.0(2) image includes a separate FPGA
image that you can upgrade independently from the NX-OS software upgrade.

The FPGA image must be downloaded to the switch’s bootflash. Remote upgrading from FTP or TFTP is not
supported.

Detailed Steps

Step 1 If you have a Cisco.com login, you can obtain the FPGA image from the following website:

http://software.cisco.com/download/release.html?mdfid=283748960&flowid=28583&softwareid=282253564&relea
se=6.2%286%29&relind=AVAILABLE&rellifecycle=&reltype=latest

Step 2 Download the FPGA image package to the switch bootflash.

See the switch documentation for more information about downloading files to bootflash.

Step 3 Upgrade using the command: install all epld bootflash:<epld-image> parallel module <module#>
command.