Cisco PowerKEY CableCARD Module Guia Do Utilizador
Configure the DNCS for CableCARD and M-Card Support
4021652 Rev B
3
Configure the DNCS for CableCARD and M-Card
Support
Support
Introduction
In order for the CableCARD or M-Card modules to function properly, you must
initially configure the DNCS. The following steps summarize the configuration
process. (Detailed configuration steps appear later in this section.)
initially configure the DNCS. The following steps summarize the configuration
process. (Detailed configuration steps appear later in this section.)
Process Overview
If you have not set up your DNCS to configure CableCARD or M-Card modules,
you need to complete the following stages. Otherwise, go to Before You Begin
(on page 3).
1 Load the EMM CD (or download the EMMs from our FTP site) and confirm that
you need to complete the following stages. Otherwise, go to Before You Begin
(on page 3).
1 Load the EMM CD (or download the EMMs from our FTP site) and confirm that
the correct CableCARD or M-Card module types exist.
Note: Refer to the Explorer Digital Home Communications Terminal Staging Guide
(part number 734375) or the Separable Security Host Staging Guide
(part number 736107) for more information.
Note: Refer to the Explorer Digital Home Communications Terminal Staging Guide
(part number 734375) or the Separable Security Host Staging Guide
(part number 736107) for more information.
2 Set up the DNCS for tru2way™ (formerly called OpenCable™) compliance.
3 Understand the binding methods offered by the DNCS.
4 Configure the CableCARD server on the DNCS.
5 Configure the MMI Screen for M-Card modules and two-way hosts.
6 Configure EAS to properly function with the CableCARD and M-Card modules.
7 Verify the setup of the CableCARD and M-Card modules on the DNCS.
3 Understand the binding methods offered by the DNCS.
4 Configure the CableCARD server on the DNCS.
5 Configure the MMI Screen for M-Card modules and two-way hosts.
6 Configure EAS to properly function with the CableCARD and M-Card modules.
7 Verify the setup of the CableCARD and M-Card modules on the DNCS.
Before You Begin
You need to obtain the EMM keys for the CableCARD and/or M-Card modules that
you intend to provision on the DNCS at this time. If your EMM CDs or files have
been lost or misplaced, you can obtain the EMM keys through our Customer Self-
Service website.
you intend to provision on the DNCS at this time. If your EMM CDs or files have
been lost or misplaced, you can obtain the EMM keys through our Customer Self-
Service website.
Note: Refer to the Explorer Digital Home Communications Terminal Staging Guide
(part number 734375) for detailed instructions for obtaining and loading EMMs
using the Customer Self-Service website.
(part number 734375) for detailed instructions for obtaining and loading EMMs
using the Customer Self-Service website.