Cisco Cisco D9887B HDTV Modular Receiver Guia Da Instalação

 

4043118 Rev A 

107 

 

 

Install Location: Any slot except 1-1 or 2-1. 

I/O: Logic Input, Open-Collector, and Relay Contact 

Description: This module is considered a global unit option. The inputs and outputs 
of a single installed module can be accessed by functions associated with general 
system features, or RDS specific features in any unit configuration. Only one GPIO 
module can be installed in a unit. 

 

To setup the D9887B receiver to interpret a contact closure from a receiver (getting 
DTMF analog cue tones) and output an embedded SCTE-104 message in the SDI 
output, use the following steps: 
1  Press the Menu button. 
2  Use the Up and Down buttons to move the cursor to "GPIO Module," then press 

the Enter button. 

 

3  Use the Up and Down buttons to move the cursor to "Input 1," then press the 

Enter button. 

 

4  Use the Up and Down buttons to select the message ("SCTE104 RDS1 1", 

"SCTE104 RDS1 2", "SCTE104 RDS1 3", "SCTE104 RDS1 4")  that is to be inserted, 
then press the Enter button to save the selection.