Cisco Cisco D9887B HDTV Modular Receiver Guia Da Instalação

 

4043118 Rev A 

109 

 

4  Use the Up and Down, and the Left and Right buttons to set the "AS Index" to 

the desired amount, and then press the Enter button. The "AS Index" ranges from 
0 to 255 and uniquely identifies the source of the message. Enter the "AS Index" if 
one is present, otherwise leave blank (0). 

 

5  Use the Up and Down, and the Left and Right buttons to set the "DPI PID Index" 

to the desired amount, and then press the Enter button. The "DPI PID Index" 
ranges from 0 to 65535 and is important when there are multiple DPI PIDs 
referenced by the PMT of one MPEG program. The user should take care to 
ensure the correct DPI PID and Video PID and PCR values (as indicated by the 
PMT) are configured on the D9887B receiver so that the splice points and 
decoded video are properly associated. Enter the "DPI PID Index" to specify the 
index to the DPI PID that will carry the splice_info_sections. 

 

6  Use the Up and Down, and the Left and Right buttons to set the "Event Source 

Index" to the desired amount, and then press the Enter button. 

 

7  For the "Splice Type:" choose ("OON", "OON Imm", "RTN", "RTN Imm", or 

"Cancel") using the Up and Down buttons, and then press the Enter button. 

 

8  Use the Up and Down, and the Left and Right buttons to set the "Program ID" to 

the desired amount, and then press the Enter button. The "Program ID" ranges 
from 0 to 65535 and is a unique identification for a viewing event in the service.