Cisco Cisco Digital Service Access Node (DSAN) 8210 Guia Da Instalação
Chapter 3 Hardware Installation
52
OL-30954-01
To Install the Crowbar Surge Protector
Complete the following steps to install the crowbar surge protector in the RF
module:
1 Begin this procedure with the housing open. See To Open the Housing (on page
module:
1 Begin this procedure with the housing open. See To Open the Housing (on page
2
Remove the RF module cover by loosening the 30 cover screws. Refer to the
following illustration.
following illustration.
Note: The RF module retaining screws, numbered 1 through 6, should remain
attached to the housing.