Cisco Headend System Release 2.7 Guia Do Utilizador
Chapter 1 Maintaining Your SDV System
14
4019781 Rev B
6 After the SDV sessions are built, if the sessions are not immediately utilized, then
disable the DNCS ATM source by following the quick path:
DNCS Administrative Console > Application Interface Modules tab > BFS
Admin > select DNCS > File > Select > Sources tab > select source to be
modified > File > Open > set source to Disable > Save
DNCS Administrative Console > Application Interface Modules tab > BFS
Admin > select DNCS > File > Select > Sources tab > select source to be
modified > File > Open > set source to Disable > Save
7 Once the PAT Configuration Table has been modified, update any secondary
BFS QAMs by tearing down any session greater than 22 and rebuilding the
session with the correct Program Number.
session with the correct Program Number.
Adding BFS Sources - Sites Using Direct ASI
Complete the following procedure if your DNCS uses the Direct ASI option to
distribute BFS data.
distribute BFS data.
Note: A benefit of using the Direct ASI option is that you only need to build sessions
as you need them on your primary and secondary BFS QAMs. There is no need to tear
down any DNCS sessions greater than 22 as you would do within a BFS QAM
system.
1 Configure your BFS source setup procedures per the Provisioning the DNCS to
as you need them on your primary and secondary BFS QAMs. There is no need to tear
down any DNCS sessions greater than 22 as you would do within a BFS QAM
system.
1 Configure your BFS source setup procedures per the Provisioning the DNCS to
Support SDV Services User's Guide (part number 4012948).
2 Manually add your BFS sources by following the quick path:
DNCS Administrative Console > DNCS tab > Source
3 As BFS sources are built, the DNCS automatically retrieves the next available
program number from the source list. As a result, there is no need to update the
PAT Configuration Table by hand.
PAT Configuration Table by hand.