Cisco Headend System Release 2.7 Guia Da Instalação
Chapter 10 Configuring Multiple Bootloader Carousels
140
4017650 Rev C
Setting Up a New Carousel
Default carousels are configured during the installation process. If you want to add a
new bootloader carousel or multiple carousels, complete the following steps.
new bootloader carousel or multiple carousels, complete the following steps.
Important: The maximum rate for a carousel is 1 Mbps. If you are setting up
multiple carousels, keep these points in mind:
multiple carousels, keep these points in mind:
The cumulative data rate for all out-of-band (OOB) bootloader carousels should
not exceed 1 Mbps.
not exceed 1 Mbps.
You should strive to keep the number of carousels to a minimum. Only add
additional carousels if they provide a significant advantage to the download
process.
additional carousels if they provide a significant advantage to the download
process.
1 From the DNCS Administrative Console, click the Application Interface
Modules tab.
2 Click BFS Admin. The BFS Admin Sites window opens.
3 Click File and then select All Sites. The Site AllSites BFS Administration window
3 Click File and then select All Sites. The Site AllSites BFS Administration window
opens.
4 On the Site AllSites BFS Administration window, click the Sources tab. The
Sources tab moves to the forefront.
5 Click File and then select New. The Set Up BFS Source window opens.
6 In the Set Up BFS Source window, fill in the fields according to your naming
6 In the Set Up BFS Source window, fill in the fields according to your naming
convention making sure that the Source Type is set to Bootloader and the
Transport Type is set to ASI In-Band.
Transport Type is set to ASI In-Band.
7 Click Save. The new source is added to the Site AllSites BFS Administration
window on the RF Sources tab.