Cisco Headend System Release 2.7 Guia Da Instalação
Chapter 5 SR 5.0 Post Upgrade Procedures
78
4042225 Rev A
Run fixSiteConfigs on the RNCS
Only perform this procedure if the site you are upgrading has an RNCS system. If
the site you are upgrading does not have an RNCS, skip this procedure and go to the
next procedure in this chapter.
This procedure fixes the /tftpboot config files for headend components. It also sets
the AlarmServerIpAddr entries to the correct IP address for the RNCS.
1 In a root xterm window on the RNCS, type the following command and press
the site you are upgrading does not have an RNCS, skip this procedure and go to the
next procedure in this chapter.
This procedure fixes the /tftpboot config files for headend components. It also sets
the AlarmServerIpAddr entries to the correct IP address for the RNCS.
1 In a root xterm window on the RNCS, type the following command and press
Enter.
fixSiteConfigs
Sample output:
# fixSiteConfigs
fixSiteConfigs: Fixing config files in lionn1:/tftpboot...
fixSiteConfigs: modified: goqam.config
fixSiteConfigs: modified: gqam.config
fixSiteConfigs: Ignoring platform file 'inet-config'
fixSiteConfigs: modified: mqam.config
fixSiteConfigs: WARNING: unknown tftpboot config file: 'nc.config'
fixSiteConfigs: no mods needed: nc.config
fixSiteConfigs: modified: qam.config
fixSiteConfigs: modified: qpsk.config
fixSiteConfigs: modified: scsmqam.config
fixSiteConfigs: 6 of 9 tftpboot config files were modified
2 Type the following command and press Enter.
cd /tftpboot
3 Verify that each of the .config files contains the correct IP addresses.
Notes:
The QAM config files contain two IpAddr variables, RpcServerIpAddr and
AlarmServerIpAddr. These entries should have the following IP addresses
assigned:
AlarmServerIpAddr. These entries should have the following IP addresses
assigned:
RpcServerIpAddr = [dncsatm IP Address]
AlarmServerIpAddr = [RNCS IP Address]
If these variables do NOT have the correct IP address assigned, contact Cisco
Services for assitance.
Services for assitance.
Ignore any inet-config and nc.config warnings.