Cisco Headend System Release 2.7 Guia Da Instalação
Set Up the RNCS
4036631 Rev B
101
Set Up the RNCS
If the site you are upgrading is licensed to support the Regional Network Control
System (RNCS), then follow the directions in this section.
System (RNCS), then follow the directions in this section.
Enable the RNCS Feature
Contact Cisco Services to enable the Distributed DNCS feature on your system.
Contact Cisco Services to enable the Distributed DNCS feature on your system.
Register RNCS With the DNCS
After the Distributed DNCS feature is licensed on the DNCS, your next step is to
register each RNCS with the DNCS. Refer to Appendix A, The siteCmd Program, in
RNCS Installation and Upgrade Instructions For SR 2.7/3.7 or SR 4.2 (part number
4012763), for an overview of the siteCmd program and for specific instructions on
registering the RNCS.
After the Distributed DNCS feature is licensed on the DNCS, your next step is to
register each RNCS with the DNCS. Refer to Appendix A, The siteCmd Program, in
RNCS Installation and Upgrade Instructions For SR 2.7/3.7 or SR 4.2 (part number
4012763), for an overview of the siteCmd program and for specific instructions on
registering the RNCS.
Provision the RNCS
After using the siteCmd program to register the RNCS with the DNCS, use the
online help of the DNCS to provision the RNCS.
Note: Provisioning the RNCS refers to adding components, such as QAMs and
QPSKs, as well as configuring the parameters on the BFS Administration GUI.
After using the siteCmd program to register the RNCS with the DNCS, use the
online help of the DNCS to provision the RNCS.
Note: Provisioning the RNCS refers to adding components, such as QAMs and
QPSKs, as well as configuring the parameters on the BFS Administration GUI.