Cisco Headend System Release 2.7 Guia Da Instalação
Chapter 1 Initial Installation of RNCS Software
36
78-4021167-01 Rev D
5 Click File > New. The Set Up BFS Host window opens.
6 Enter the following information:
BFS In-Band Mode (ATM)
Inband Device Name
Note: You can leave this field at its default setting.
Note: You can leave this field at its default setting.
Host Name
Note: The hostname should be the same hostname that you entered in step
Note: The hostname should be the same hostname that you entered in step
10 of Install the RNCS Software (on page 11).
Note: Any additional selectable parameters on the Set Up BFS Host window are
not needed when ATM is selected as the BFS In-Band Mode.
7 Click Save.
Enabling RF or IP Sources for the New Site
Refer to Recommended Data Carousel Rate Settings (on page 85) for guidance when
configuring these sources.
1 From the BFS Admin Sites window, double-click the site you just created.
2 Choose one of the following options:
1 From the BFS Admin Sites window, double-click the site you just created.
2 Choose one of the following options:
If your site uses RF sources, go to step 3.
If your site uses IP-only sources, go to step 6.
3 Click the RF Sources tab.