Cisco Headend System Release 2.7 Guia Da Instalação
Chapter 1 Initial Installation of RNCS Software
14
4022447 Rev B
6 Type setsc netsc_ipnetmask [netmask] and press Enter. This command
establishes the netmask of the network management port.
Notes:
Notes:
Substitute the netmask of the network management port of the RNCS server
for [netmask].
for [netmask].
The network administrator can help you determine the netmask.
7 Type setsc netsc_ipgateway [IP address of gateway or router] and press Enter.
This command establishes the IP address of the gateway or router of the network
management port.
Notes:
management port.
Notes:
Substitute the IP address of the gateway or router of the network
management port of the RNCS server for [IP address of gateway or router].
management port of the RNCS server for [IP address of gateway or router].
The network administrator can help you determine the IP address.
8 Type setsc sc_powerstatememory true and press Enter. This command sets the
sc_powerstatememory variable to true.
9 Type showsc and press Enter. The system displays the value of variables
associated with the ALOM port.
10 Is the sc_powerstatememory variable set to true?
If yes, type q to exit from the showsc display.
If no, type q to exit from the showsc display. Repeat this procedure from step
8.
8.
11 Type resetsc and press Enter. A confirmation message appears.
12 Type y and press Enter. After a few messages, the system prompts you to type #.
12 Type y and press Enter. After a few messages, the system prompts you to type #.
to return to the ALOM port.
13 Type #. (Do not press Enter.). The Login prompt appears.
14 Did the Login prompt appear after you completed step 13?
14 Did the Login prompt appear after you completed step 13?
If yes, go to step 15.
If no (the sc> prompt appeared), go to step 16.
15 If the Login prompt appeared after you completed step 13, follow these
instructions.
a Type admin and press Enter.
b Type the admin password and press Enter. The sc> prompt appears.
a Type admin and press Enter.
b Type the admin password and press Enter. The sc> prompt appears.
16 Type shownetwork and press Enter. The system displays the configuration
settings you just established.
17 Review the settings you established in steps 1 through 16 and choose one of the
following options:
If the settings are correct, go to step 18.
If a setting is incorrect, re-run the appropriate command and then go to step
18.
18.