Cisco Headend System Release 2.7 Referências técnicas

Página de 8
 
4024316 Rev B 
 
About This Bulletin 
 
 
 
Download M-Card Code 
Note: An M-Card software download should not be attempted without involving 
Cisco Services. 
Before you begin, it is assumed that: 
 
The output frequency has been changed on all BFS QAMs in your system. 
 
All sessions and programs have been restored. 
 
You have previously obtained the latest M-Card software from Cisco Services. 
 
The software is staged for download to M-Card modules. 
 
Cisco Services is assisting in the task.  
If all of these criteria have been met, download the M-Card software according to the 
procedures and guidance provided by Cisco Services.  
Note: When the software download process is complete, verify that each M-Card 
module is running the new software, test PPV, xOD, and third-party applications 
and confirm normal set-top behavior. 
 
Restore the Original Configuration on the BFS QAM 
Note: This task is optional. If you allow your BFS QAM output frequency to remain 
above 204 MHz, you will be able to download software to your M-Card modules, 
regardless of what software version is running on them. However, if you restore a 
sub-204 MHz output frequency, it will be necessary to perform the tasks in this 
Operations Alert Bulletin again, if M-Card modules with software prior to OS 1.5.2 
are deployed in your system at a later date. 
Before you begin, be sure you have successfully downloaded software to all M-Card 
modules. 
 
1  See 
Change the BFS QAM Output Frequency (on page 2) for instructions and 
change the BFS QAM output frequency to the original value.  
2  Follow the instructions in 
Reboot the BFS QAM and Verify Counts (on page 4) t
apply the changes to the BFS QAM. 
3  Repeat steps 1 and 2 for all BFS QAMs in your system.