Cisco Cisco Prisma II EDR Receiver Guia Da Instalação
Chapter 3 Operation using ICIM
66
ALARMS Menus
When a module ALARMS menu is selected, press the
key or the
key
to scroll through alarms. Some typical ALARMS menus are shown below.
A L A R M S
A L A R M S
S h e l f
5
S l o t 1 2
S h e l f
5
S l o t 1 2
P 2 - E D R - R X
O p t P i n 1
F a u l t
P 2 - E D R - R X
O p t P i n 2
F a u l t
A L A R M S
S h e l f
5
S l o t 1 2
P 2 - E D R - R X
R x 1 _ D a t a
F a u l t
A L A R M S
S h e l f
5
S l o t 1 2
P 2 - E D R - R X
R x 2 _ D a t a
F a u l t
Note: For details on all alarm parameters, see Module Parameter Descriptions (on
page 109).
page 109).
To Set Adjustable Alarm Thresholds using the ICIM
You can use the ICIM to change the adjustable alarm thresholds of this module from
their factory default values.
their factory default values.
1 At the MODULE menu, press the
key. The STATUS menu appears on the
ICIM LCD.
2 Press the
key. The alarm thresholds previously set are displayed. If the
label n/a is displayed, you cannot configure that alarm threshold. Press the
key to highlight the alarm threshold for the next parameter.
3 When the threshold that you wish to set is highlighted, press the
key.
4 Press the
key or the
key to change the increment size.
5 Press the
key or the
key to adjust the alarm threshold.
Note: Press the Cancel (
) key to return to the previous menu.
6 Press the
key to save the changes. The message Data Saved appears on
the ICIM LCD.
7 When finished, press the
key to return to the MAIN menu.