Cisco Cisco Unified Contact Center Enterprise 9.0(1) Guia Do Utilizador
C H A P T E R
2-1
SS7 Gateway Configuration Tool User Guide for Cisco ICM Enterprise & Hosted Editions Release 8.0(1)
2
Using SS7Cfg to Configure Your Gateway
Overview
For the purposes of this exercise, the following sample network configuration will be used to set up an
SS7 Generic (ITU) gateway using SS7Cfg.
SS7 Generic (ITU) gateway using SS7Cfg.
Note
The example exercise configures the network interface from the bottom up, which is consistent with the
way SS7Cfg was defined. (Notice that only Gateway 1 will be configured in this example.)
way SS7Cfg was defined. (Notice that only Gateway 1 will be configured in this example.)
In
, Gateway 1 has four links connecting to two different Signal Transfer Points (STPs). Each
STP is connected by two links combined into a linkset. Gateway 1 has a point code of 150 and is
connected to two STPs with point codes of 10 and 11. Behind the STPs are two Service Switching Points
(SSPs) at point codes 200 and 201.
connected to two STPs with point codes of 10 and 11. Behind the STPs are two Service Switching Points
(SSPs) at point codes 200 and 201.
Figure 2-1
SS7 Gateway Links
Starting SS7Cfg
Start SS7Cfg by following the instructions below.
Gateway 1
PC 150
Gateway 2
PC 151
STP
PC 10
STP
PC 11
SSP1
PC 200
SSP2
PC 201
37785