Cisco Cisco IPCC Web Option Referências técnicas
Data Link Configuration
17
17
17
The new Data Link Configuration Utility (accessed through the Hardware
Administrator) is shown in Figure 3.
Administrator) is shown in Figure 3.
Figure 3: Data Link Configuration Utility
The Properties Page for the selected Interlink contains several tabs. The General
tab is shown in Figure 4.
tab is shown in Figure 4.
Figure 4: General Tab
The “Backup Link” parameter MUST be set to “None (0)”. This setting
eliminates duplicate messaging and link alarms. Link alarms are generated when
the PIM for the “backup” link is the active side. (The Application has logic to try
the primary link before the backup. When the primary link fails, a warning is
generated even though the call is handled correctly).
eliminates duplicate messaging and link alarms. Link alarms are generated when
the PIM for the “backup” link is the active side. (The Application has logic to try
the primary link before the backup. When the primary link fails, a warning is
generated even though the call is handled correctly).
WARNING: Use of the “Backup Link” parameter causes an unacceptable PIM
behavior. DO NOT configure a link for the “Backup Link”.
behavior. DO NOT configure a link for the “Backup Link”.