Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

You must use the System Setup Wizard for the initial setup in order to ensure a complete configuration. 
Later, you can configure custom options not available in the System Setup Wizard. 

You can run the System Setup Wizard using a browser or the command line interface (CLI). For more 
information, see 

 or 

Before you begin, complete the prerequisites at 

. 

If you are setting up a virtual Email Security appliance, you will have to use the 

loadlicense

 command 

to load your virtual appliance license before running the System Setup Wizard. See the Cisco Content 
Security Virtual Appliance Installation Guide for more information.

The System Setup Wizard will completely reconfigure your system. You should only use the System 
Setup Wizard the very first time you install the appliance, or if you want to completely overwrite your 
existing configuration.

The Email Security appliance ships with a default IP address of 

192.168.42.42

 on the Management 

port of all hardware except C170 appliances, which use the Data 1 port instead. Before connecting the 
appliance to your network, ensure that no other device’s IP address conflicts with this factory default 
setting. If you are configuring a Cisco Content Security Management appliance, please see 

IPv6 Address / Prefix:

Fully Qualified Hostname:

SenderBase Reputation Filtering:

Enable / Disable

Anti-Spam Scanning Engine

None / IronPort

McAfee Anti-Virus Scanning Engine

Enable / Disable

Sophos Anti-Virus Scanning Engine

Enable / Disable

Outbreak Filters

Enable / Disable