Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

Enter the host name for the Active Directory server.

Enter a username and password for the authentication request.

Click Next to continue.

The Active Directory Wizard tests the connection to the Active Directory server. If successful, the Test 
Directory Settings page is displayed.

Test the directory settings by entering an email address that you know exists in the Active Directory and 
clicking Test. The results appear in the connection status field.

Click Done.

After you successfully configure your appliance to work with your Active Directory Wizard, or skip the 
process, the System Setup Next Steps page appears.

Click the links on the System Setup Next Steps page to proceed with the configuration of your 
appliances. 

Access to the CLI varies depending on the management connection method you chose in 

. The factory default username and password are listed next. Initially, only the 

admin user account has access to the CLI. You can add other users with differing levels of permission 
after you have accessed the command line interface for the first time via the admin account. (For 
information about adding users, see 

.) The System Setup Wizard asks you to 

change the password for the admin account. The password for the admin account can also be reset 
directly at any time using the password command. 

To connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 
192.168.42.42. SSH is configured to use port 22. Telnet is configured to use port 23. Enter the username 
and password below. 

To connect via a Serial connection: Start a terminal session with the communication port on your 
personal computer that the serial cable is connected to. Use the settings for serial port outlined in 

. Enter the username and password below. 

Log in to the appliance by entering the username and password.

Username: 

Password: