Samsung DVD-HR753 Manual Do Utilizador

English - 23

 

To use HDMI cable (not supplied), make the 
Audio/Video connection before plugging in the 
power cord or after fi nishing the “Plug & Auto 
Setup.” Do not connect the HDMI cable while 
the “Plug & Auto Setup” is progressing. 
Progressive scan automatically activates when 
HDMI is connected.
If your TV does not have Bitstream decoder, 
you must set the digital audio output to PCM in 
order to watch through the HDMI output. 
(See pages 33~34)
Depending on the HDMI device (TV/HDMI 
Receiver) you use, audio may not be 
supported. If TV/HDMI Receiver does not 
support Dolby digital, Audio output is not 
available when you set Digital output as 
‘Bitstream’ in Audio setup menu. In this case, 
set the digital audio output to PCM. If TV/HDMI 
Receiver does not support DTS, Audio output 
is not available when you play disc in DTS 
format.
You can switch from the HDMI output to other 
output only in stop mode.
If you use an HDMI cable to connect a 
Samsung TV to the HDD & DVD RECORDER, 
you can operate the recorder using the TV 
remote control. 
(This is only available with SAMSUNG TVs 
that support Anynet+(HDMI-CEC).)
(See page 31)
Please check the 

n logo (If your TV has 

an 

n logo, then it supports Anynet+ 

function.)

J















If your TV has a HDMI/DVI input, connect HDMI/DVI 
Adapter cable to a TV. You will enjoy the best quality 
images and sounds.

Case 1 : Connecting to a TV with HDMI Jack
Case 2 : Connecting to a TV with DVI Jack

Using the HDMI cable (not supplied) connect the 
HDMI OUT jack on the rear of the HDD & DVD 
RECORDER to the HDMI IN jack of your TV.
Press the input selector on your TV remote control 
until the HDMI signal from the HDD & DVD 
RECORDER appears on your TV screen.

Using the DVI Adapter cable (not supplied), connect 
the HDMI OUT jack on the rear of the HDD & DVD 
RECORDER to the DVI IN jack of your TV.
Using the audio cables, connect the AUDIO (red and 
white) OUT jacks on the rear of the HDD & DVD 
RECORDER to the AUDIO (red and white) IN jacks 
of your TV. Turn on the HDD & DVD RECORDER 
and TV.
Press the input selector on your TV remote control 
until the DVI signal from the HDD & DVD 
RECORDER appears on your TV screen.

•
•

•

•

•

•

•