Alesis studio24 Manual Do Utilizador
Hooking It Up
3 4 S
TUDIO
24 R
EFERENCE
M
ANUAL
P
OWER
Make sure you read the initial Important Safety Instructions chapter
at the front of this manual.
at the front of this manual.
The Studio 24 works with a single standard line voltage and comes with a detachable
AC line cord suitable for the destination to which the mixing console is shipped.
Units sold in the United States are designed for use with 110 to 120 volt AC power
only (nominal 60 Hz).
AC line cord suitable for the destination to which the mixing console is shipped.
Units sold in the United States are designed for use with 110 to 120 volt AC power
only (nominal 60 Hz).
The line cable is an IEC-spec AC power cable (do not substitute any other AC cord),
which is designed to be connected to an outlet that includes three pins, with the
third, round pin connected to ground. The ground connection is an important safety
feature designed to keep the chassis of electronic devices such as the Studio 24 (and
all microphones connected to it) at ground potential. Unfortunately, the presence of a
third pin does not always indicate that an outlet is properly grounded. You may use
an AC line tester to determine this. If the outlet is not grounded, consult with a
licensed electrician. When AC currents are suspected of being highly unstable in
VAC and Hz, a professional power conditioner should be used.
which is designed to be connected to an outlet that includes three pins, with the
third, round pin connected to ground. The ground connection is an important safety
feature designed to keep the chassis of electronic devices such as the Studio 24 (and
all microphones connected to it) at ground potential. Unfortunately, the presence of a
third pin does not always indicate that an outlet is properly grounded. You may use
an AC line tester to determine this. If the outlet is not grounded, consult with a
licensed electrician. When AC currents are suspected of being highly unstable in
VAC and Hz, a professional power conditioner should be used.
To connect power to the Studio 24:
1
Attach the female end of the AC power cord to the Studio 24’s back panel and
the male end to a good quality, noise-free AC power source of the proper rating.
the male end to a good quality, noise-free AC power source of the proper rating.
2
To apply power to the Studio 24, switch on the POWER switch on the back panel,
so that it is in the | (on) position.
so that it is in the | (on) position.
Do not operate any electrical equipment with ungrounded outlets.
Plugging the Studio 24 into an ungrounded outlet, or “lifting” the
unit off ground with a three-to-two wire adapter, can create a
hazardous condition. Alesis cannot be responsible for problems
caused by using the Studio 24 or any associated equipment with
improper AC wiring.
Plugging the Studio 24 into an ungrounded outlet, or “lifting” the
unit off ground with a three-to-two wire adapter, can create a
hazardous condition. Alesis cannot be responsible for problems
caused by using the Studio 24 or any associated equipment with
improper AC wiring.