Alesis studio24 Manual Do Utilizador

Once you have recorded onto the multitrack tape machine, you’ll need to hear the
playback of those tracks, as you record new tracks in sync with the material already
on tape (see next section, Getting the Mix to Headphones). The signals coming back
from the multitrack tape machine connect to the TAPE IN connectors of each
channel, and during the overdubbing stage you’ll usually hear them via the
MONITOR 1/2 system.

Place the tracks of the tape machine you wish to monitor into the “Tape” or
“Playback” position. Usually this is done simply by taking the tracks out of
Record mode.

Make sure the CHAN/MON REVERSE button is up on each Channel that will be
used to monitor the tape tracks. Raise the MON 1/2 LEVEL knobs on each
Channel being used for the tape tracks you want to hear.

Select MON 1/2 as the Control Room Source.

: Alternatively, you may select L/R as the Control Room source, and press the

“LINK TO L/R” switch under the MONITOR 1/2 MASTER. This will allow you
to hear other sources from the Channel faders if they are assigned to L/R.

Play the tape and raise the MONITOR 1/2 MASTER until the peaks of the signal
briefly light the yellow LEDs in the meters.

urn the CONTROL ROOM control knob up to the desired listening level.