Antares autotune4 Manual Do Utilizador
31
ONSET RATE
Sets the amount of time (in msec) between the end of the Onset Delay
set above and the point at which the vibrato reaches the full Amounts
set in the Pitch, Amplitude and Formant Amount settings. The range is
from 0 to 1500ms (1.5 seconds). The default value is 500ms. Double-
clicking the knob will reset it to that value.
set above and the point at which the vibrato reaches the full Amounts
set in the Pitch, Amplitude and Formant Amount settings. The range is
from 0 to 1500ms (1.5 seconds). The default value is 500ms. Double-
clicking the knob will reset it to that value.
Onset Example: As an example of the above parameters, assume an
Onset Delay of 1000ms and an Onset Rate of 750ms. In that case, each
time a new note started there would be no vibrato at all for the first
second (1000ms) followed by a 3/4 second (750ms) period during which
the vibrato depths would increase from none to the full amounts set in
the various Amount parameters - for a total of 1.75 seconds from the
beginning of the note to the time full vibrato depth was reached.
Onset Delay of 1000ms and an Onset Rate of 750ms. In that case, each
time a new note started there would be no vibrato at all for the first
second (1000ms) followed by a 3/4 second (750ms) period during which
the vibrato depths would increase from none to the full amounts set in
the various Amount parameters - for a total of 1.75 seconds from the
beginning of the note to the time full vibrato depth was reached.
PITCH AMOUNT
Sets the amount that the pitch changes. The range is from 0 (no
change) to 100 (maximum change). The default setting is 18. Double-
clicking the knob will reset it to that value.
change) to 100 (maximum change). The default setting is 18. Double-
clicking the knob will reset it to that value.
AMPLITUDE AMOUNT
Sets the amount that the loudness changes. For the most realistic
vibrato, the amount of amplitude change should be substantially less
than pitch change, although for special effects, anything goes.
vibrato, the amount of amplitude change should be substantially less
than pitch change, although for special effects, anything goes.
The range is from 0 (no change) to 30 (maximum change). The default
setting is 10. Double-clicking the knob will reset it to that value.
setting is 10. Double-clicking the knob will reset it to that value.
FORMANT AMOUNT
Sets the amount that the resonant timbre changes. The range is from 0
(no change) to 100 (maximum change). The default setting is 70.
Double-clicking the knob will reset it to that value
(no change) to 100 (maximum change). The default setting is 70.
Double-clicking the knob will reset it to that value
The vibrato is re-started every time the Auto-Tune 4 matches the
incoming pitch to a different scale tone. Also, the vibrato is applied
after the effects of the Retune Speed control. Hence, even with a slow
retune value of 50, a square wave vibrato will make instantaneous
changes in pitch.
incoming pitch to a different scale tone. Also, the vibrato is applied
after the effects of the Retune Speed control. Hence, even with a slow
retune value of 50, a square wave vibrato will make instantaneous
changes in pitch.