3com 3800 Manual Do Utilizador

SmartRedundancy for the Switch 3800 refers to fail-over behavior of 
the main and standby Gigabit Ethernet ports. SmartRedundancy allows 
the Switch to always use the main link if it is available. For example, if 
only the standby link is available it will be used, but if the main link 
becomes available again the link will switch back to the main from the 
standby. With SmartRedundancy disabled, the first link available will be 
used; only if that link becomes unavailable will the Switch attempt to 
use the other link. By default, SmartRedundancy is enabled. 

Table 3-8   Port Commands 

config port <portlist> auto on

Allows you to enable autonegotiation on a 10/100 
Mbps or Gigabit port.

config port <portlist> auto off {speed 
[10 | 100]} duplex [half | full]

Allows you to change the configuration of a group of 
10/100 Mbps ports. Specify the following:

■

auto off — The port will not autonegotiate the 
settings.

■

speed — The speed of the port (for 10/100 Mbps 
ports only).

■

duplex — The duplex setting (half- or full-duplex).

config port <portlist> auto off duplex 
full

Allows you to disable autonegotiation on a Gigabit 
port.

enable port <portlist>

Allows you to enable one or more ports.

enable sharing <master_port> grouping 
<portlist>

Allows you to define a load-sharing group of ports. 
The ports specified in <portlist> are grouped to the 
master port.

enable smartredundancy <portlist>

Allows you to enable the SmartRedundancy feature on 
the redundant Gigabit Ethernet port. When the 
SmartRedundancy feature is enabled, the Switch 
always uses the primary link when the primary link is 
available. The default setting is enabled.

disable port <portlist>

Allows you to disable one or more ports. Even when 
disabled, the link is available for diagnostic purposes.

disable sharing <master_port>

Allows you to disable a load-sharing group of ports.

(continued)

SW3800.BK  Page 17  Tuesday, May 5, 1998  5:20 PM