Arcam DT91 Manual Do Utilizador
DT91
E-8
E
n
g
li
s
h
DT91
E-9
Technical specifications
Digital audio output
Format
SPDIF co-axial to gold-plated phono sockets
SPDIF optical to TOSLINK
SPDIF optical to TOSLINK
Sample rate
48kHz (DAB mode)
32kHz (FM mode)
32kHz (FM mode)
Output impedance (co-axial)
75Ω unbalanced
Analogue audio output
Connectors
Two pairs of stereo outputs to gold-plated phono sockets
Output level
2.4Vrms at 0dB FS (DAB mode)
0.9Vrms at full modulation (FM mode)
0.9Vrms at full modulation (FM mode)
Output impedance
<100Ω
Minimum load
600Ω
Frequency response (±0.5dB)
20Hz–20kHz
RF performance (DAB mode)
Tuning range
174–240MHz (Band III)
1452–1492MHz (L band)
1452–1492MHz (L band)
Sensitivity (VHF measurement to EN50248)
better than –91dBm, typically –97dBm
Audio data rate (maximum)
224kbits/s at MPEG protection level 3
RF performance (FM mode)
Tuning range
87–108MHz
Sensitivity (IHF)
3µV typical
Signal to noise ratio
65dB at full modulation, 1kHz
THD+n
0.1% at full modulation, 1kHz
Aerial
Connector
F type
Impedance
50Ω
Remote control interface
Remote bus input
36kHz modulated RC5 on 3.5mm mono jack socket
Serial port
RS232 to 9-way male D connector, DTE pin out. Remote
control codes given in table on following page.
control codes given in table on following page.
General
Supply voltage
115 or 230Vac, set by rear panel voltage selector switch
Power consumption
<20W
Size
W435 x D320 x H83mm
Weight
3.6kg (net), 6kg (packed)
Supplied accessories
CR-389D remote control
two x AAA batteries
Mains lead
Indoor ribbon aerial
two x AAA batteries
Mains lead
Indoor ribbon aerial
E&OE
Note: All specification values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and specifications
are subject to change without notice.
are subject to change without notice.